Command. The screen will show: -
You may set the Second field to ON or OFF by pressing the
<D> Key. When the desired value is shown, press the <#> Key
to accept. After chosen, the screen reverts back to the SUB-
MENU display.
If you select ‘ON’, you will get the second field transaction in
your software.
4.3.4
Clear Transactions
This command is for clearing memory of transaction buffer. On
executing this command, the following screen appears:-
You can now opt to clear buffer of either door 1 or door 2. To
select door 1, key in “ 0 1 <#> “, and for selecting door 2, key in “ 0
2 <#> “.
4.3.5
Log Transactions
This command allows you to choose what events you wish to log
in the transaction buffer. For example, suppose you only wish to
log valid card entry (code 0) and valid card exit (code 9), then you
simply put these 2 codes in, and the equipment will only record
these 2 activities, and all other activities will not be logged.
On entering this command, the screen will show: -
To Next Page
