This board is only required when you cold start the controller and
setting of engineering menu. Thus, it is an optional board.
EL2316D can run without this board in normal operation.
ELID offers a wide range of readers that may be used in EL2316D.
Some of these are listed below: -
a)
Keypad
EK9S - Keypad with 4x7 segment display
b)
Readers
ERH23 / ERH923 - HID Proximity Reader
ERM823 / ERM923 - EM Proximity Reader
ER928 - Mifare contactless smart card reader
c)
Keypad - Reader
EK9R - Keypad with 4x7 segment display & EM Proximity reader
For serial readers using 4 7-segment display, the indications for
different status are as follows: -
E-RD If the card has unrecognizable codes, which may be due
to swiping the card incorrectly, or damage to the card,
the display will show "E-RD", which means Error-Read.
E-CC If the card's customer code does not match the
controller's customer code, the display will show "E-CC",
which means Error-Customer Code.
E-IC If the number is not found in the memory, the display will
show "E-IC", which means Error-Invalid Card.
E-CA If the number is found in the memory, but the time zone
category of the card is such that it cannot enter the door
at this particular time, the display will show "E-CA", which
means Error-Category.
To Next Page
