Elkron MP110 - Factory parameters: miscellaneous parameters; Factory parameters: outputs

(((ELKRON))) - MP110
FACTORY PROGRAMMABILITY
Input time 0 sec. 0 to 90 sec.
Output time Input time + 10 sec. Non programmable
Alarm time 1 minute 30 sec to 9 min.
Alarm count 0 (bypassed) 0 to 9
Prealarm Armed Armed/disarmed
Masking Disarmed Armed/disarmed
Mechanical key Impulsive Level or impulsive
Cyclic key Disabled Disabled/ at intervals from 1 hour to 7 days
OUTPUT CONFIGUR U01 U02 U03 U04 U05 Ux1 Ux2 Ux3
Burglary alarm
Tamper alarm
Panic alarm
Fire alarm
Technological alarm
CHIME signalling
LPA output
TC1 status
TC2 status
TC3 status
OR of TC1, TC2, TC3
AND of TC1, TC2, TC3
Reset output
Buzzer piloting
Ux4
System status
Open inputs
Telephone line status
CONTROL UNIT OUTPUTS
3.1.7 Factory parameters: miscellaneous parameters
3.1.8 Factory parameters: outputs
EXPANSIONS OUTPUTS
HOW TO READ TABLE
The symbol indicates
the zone as pro-
grammed in factory.
The symbol indicates
that the zone may be
programmed.
The white space indi-
cates that the zone may
not be programmed.
Fault output
NH/NL level
NPN/PNP type
25