Elkron MP110 - Page 42

(((ELKRON))) - MP110
4.4.3 Disarming with anti-robbery code
• The performance can be obtained only by means of the keypads.
• The disarming procedure described in para 4.4.1 is carried out, but it is
necessary to enter the code increasing the last digit by one unit.
• Example: code 123456 would become 123457; code 132459 would
become 132450.
The system turns off regularly but a 30s timeout is enabled during which
if a correct code is not entered for the second time, a SILENT PANIC alarm
will be generated on the programmed output and it will send the telephone
alarms to all the numbers associated to the panic event. The event is not
recorded in the event log.
4.4.4 Lock of alarms in progress
• The acknowledgement of a correct code (keypad entry, reading of a key,
or mechanical key arming) immediately stops all alarms thay may be in
progress exception made for the communicator. The communicator
stop can be carried out by disarming the system (for burglary events
only).If the communicator has already started a transmission, the
current call is completed and the following ones are cancelled.
4.4.5 Attempt to enter a wrong code
• In case of introduction of a wrong code for 4 consecutive times, the
system visualizes a tamper on the keypads and the readers. When
introducing a wrong code for the fifth consecutive time, the system
starts a tamper alarm.
42