Elmo GS-800 - Voltage Selection. ·40

Voltage selection
Voltage can be adjusted to comply with electrical requirements of each country.
(There is a single voltage model that complies with the electrical regulations
and
condition of each country .)
No t e:
o
•
•
Disconnect the power cord .
Looses screws and remove the rear cover.
Pull out the voltage selection plug.
Align the notch with the required
voltage and then insert the plug back
into the socket so that the voltage can
be read through the notch.
Projector sold in the USA is not designed for voltage alteration .
40
Adjust the tone with the tone control
knob.
Reverse projection
Advance the motor switch counter-
clockwise to "(]~,, through "OF F"
and"R~".
ME
.............. . ---- .
o 10 0 10
~ TONE
; .· 0; ·8
. . R·
o 10
Iil l SILENT I@ I <-.
Tone control knob
If film loop is lost
during projection,
press down the loop
former.
~
-~) LOOP
Loop former
13