Elmo GS-800 - Page 47

Projection
8
Pl ace your reel with film on the front
arm and take-up reel on the rear arm,
and press the
reel locks until reels are
snugged against spindles.
Note :
Be sure
to use the take-up reel supplied w ith
the projector.
Se lect the sound mode by pushing the
sound selector in accordance with the
type of film to be projected . (M fo r
magnetic sound
film, 0 fo r optical
sound fi lm or SI LENT for silent film .)
Mode l M does not have optica l sound
reproduct i on facil ity.
Set the stereo-mono se l ector for
STEREO or MONO in accordance
with the sound film.
Select projection speed, either 18 or
24 fps.
Note :
1. Set the speed knob in the middle.
2. Standard speed for magnetic sound film
is either 18 or 24 fps. S tandard speed
for optical sound f i lm is 24 fps .
Be sure
that the motor is off when changing
projection speed.
.~.
o 10
Ii5I SILENT Iwl
ft ••
Projection speed selector
• Sound editor 912/S
Incorporates S uper 8/ Single 8 mag-
netic sound reproduction facility.
Capable of flickerless projection at the
constant speed of 18 and 24 fps. For
editting convenience, possible to
adjust projection speed at the range of
10-30 fps continuous ly. Large 120 x
90 mm built-in screen assures you
bright and clear image projection .
• Editor 912
Accepts both Super 8 and Regular 8
film . Includes sound monitor, film
counter and film cleaner as optional
attachments. An easy-to-handl e,
qual ity edito r with a large, bright
screen for produc ing fine sound or
si l ent fi lm .
• Daylight projection mirror
This accessory mirror provides a
clear
projection image under daylight
conditions when used with the special
Elmo translucent rear projection
screens .
• Translucent screens
60 cm x 80 cm (23.6" x 31 . 5")
39 cm x 52 cm (15.4" x 20.5")
Special quality screens for rear pro-
jection under daylight condition .
45