Elmo SimplIQ Series - BH - Get Recorded Signal as Hexadecimal

BH - Get a Single Recorded Signal as Hexadecimal
Purpose:
Uploads the values recorded by the recorder to a host. The BH command is designed to
optimize data transfer from the drive to the host, assuming that the host has the
computing power to analyze the drive message.
Attributes: Type: Command, Integer, Bit-field
Source: RS-232
Restrictions: RR=0 (valid recorder data is ready),
Not while executing a previously-requested
BH=n command
Unit modes: All
Activation: Immediate
Reference chapter in the SimplIQ Software Manual:
Chapter 7.4, “The Recorder”
SimplIQ Command Reference Manual Alphabetical Listing
MAN-SIMCR (Ver. 4.5)
3-11