DF/DS - Download Firmware
Purpose:
Downloads a new firmware version. These commands are designed as part of a sequence
that is normally performed and controlled by the Composer program, which reads the
firmware update file provided by Elmo, and performs a sequence of actions that includes
the DF/DS command.
Notes:
After new firmware is downloaded, the drive reboots. All data stored in
temporary variables in the RAM is lost.
Loading new firmware does not normally affect the non-volatile application
variables in the data flash memory. Downloading a major software revision may,
however, destroy the non-volatile data. The Composer program will warn you of
risks of non-volatile data losses.
The DS command is used for downloading the new firmware version for the
SimplIQ drive’s sub-processor.
Attributes: Type: Command
Source: RS-232 only
Restrictions: MO=0, Program not running
Unit modes: All
Activation: Immediate
SimplIQ Command Reference Manual Alphabetical Listing
MAN-SIMCR (Ver. 4.5)
3-29
To Next Page
Loading...
