Notes:
Each type of Elmo drive supports a different number of digital inputs. Please
consult the drive’s Installation Guide for more information about its inputs.
For compatibility reason inputs 7-10 do not have an indication for the “General
Purpose” function and cannot be used for user program AUTO routine as well.
Bits 22-25 will still be set regardless to the above.
The logical state of digital input pins 1 to 10 — as indicated in bits 16 to 25 — is
reflected in the logic level required in the relevant IL[1] to [10], respectively. IB[N]
may be more convenient than IP for user program decisions and branching.
However, it is not recommended for the synchronized reading of several input
bits. If such a reading is needed, use the IP command.
Attributes: Type: Status report, Integer
Source: Program, RS-232, CANopen
Restrictions: None
Unit modes: All
See also:
IB[N], IL[N]
SimplIQ Command Reference Manual Alphabetical Listing
MAN-SIMCR (Ver. 4.5)
3-76
To Next Page
Loading...
