PIKprog
Introduction
PIKprog is little and powerful portable programmer for
Microchip PIC series of microcontrollers. PIKprog enables also
programming serial EEPROM with interface types IIC (24Cxx),
Microwire (93Cxx) and SPI (25Cxx). The programmer is
equipped by DIL ZIF 40pin socket. The quality of programmer
is completed by comfortable control program.
PIKprog interfaces with the IBM PC 486 compatible or higher,
portable or desktop personal computers. Programmer allows
you to directly connect to your PC through any standard
parallel (printer) port - no special interface card is needed.
PIKprog programmer is driven by an easy-to-use control
program with pull-down menu, hot keys and on-line help.
Selecting of device is performed by its class, by manufacturer
or simply by typing a fragment of vendor name and/or part
number.
Standard device-related commands (read, blank check,
program, verify, erase) are boosted by some test functions,
and some special functions (autoincrement).
All known data formats are supported. Automatic file format
detection and conversion during load of file.
The rich-featured autoincrement function enables to assign
individual serial numbers to each programmed device - or
simply increments a serial number, or the function enables to
read serial numbers or any programmed device identification
signatures from a file.
For PIKprog programmer are available DIL to SOIC socket
converters.
Connecting PIKprog programmer
to PC
Switch off the PC and programmer. Insert the connection
cable, included in the PIKprog programmer delivery, to the free
printer port of PC. If your computer is equipped with only one
printer port, substitute the programmer cable for the printer
cable. Connect the opposite cable end to the programmer.
Screw on both connectors to counter connectors. This is very
important mainly for the connector to programmer. Though
replacing the printer cable by the programmer cable is
uncomfortable, it is not recommended to operate the PIKprog
101
To Next Page
Loading...