Elnec JetProg - Buffer

ELNEC s. r. o.
Device / Test
This command executes a test with device selected from list of
supported devices (e.g. static RAM) on programmers, which
support this test.
Device / Device info
The command provides additional information about the
current device - size of device, organization, programming
algorithm and a list of programmers (including auxiliary
modules) that supported this device. You can find here
package information and other general information about
current device too.
The reserved key <Ctrl+F1> will bring out this menu from any
menu and any time immediately.
Buffer
This submenu is used for buffer manipulation, block operation,
filling a part of buffer with string, erasing, checksum and of
course editing and viewing with other items (find and replace
string, printing...).
Buffer / View/Edit
This command is used to view (view mode) or edit (edit mode)
data in buffer (for viewing in DUMP mode only). Use arrow
keys for select the object for edit. Edited data are signified by
colour.
You can use <F4> hot key also.
View/Edit Buffer
F1 display help of actual window
F2 fill block causes filling selected block of
buffer by requested hex (or ASCII) string.
Sets start and end block for filling and
requested hex or ASCII string.
Ctrl+F2 erase buffer with specified blank value
Ctrl+Shift+F2 fill buffer with random data
F3 copy block is used to copy specified
block of data in current buffer on new
address. Target address needn't be out
from source block addresses.
F4 move block is used to move specified
block of data in current buffer on new
address. Target address needn't be out
from source block addresses. Source
134