ELNEC s. r. o.
Introduction
T51prog is a new generation of Windows
95/98/ME/NT/2000/XP based ELNEC specialized
programmers. Programmer is capable to support all today
available microcontrollers of MCS51 series (up to 40 pins) and
AVR microcontrollers (8-40 pins) by parallel and serial way.
T51prog has been developed in close cooperation with Atmel
W&M., therefore programmer's hardware is focused to support
all current and future microcontrollers of Atmel W&M MCS51
family.
T51prog is little, very fast and powerful portable programmer
for MCS51 series and Atmel AVR microcontrollers. T51prog
enables also programming of serial EEPROM with IIC (24Cxx),
Microwire (93Cxx) and SPI (25Cxx) interface types. Using
build-in in-circuit serial programming (ISP) connector
programmer is capable to program MCS51 family
microcontrollers and Atmel AVR microcontrollers in serial way.
Provides very competitive price but excellent hardware design
for reliable programming. Nice "value for money" in this class.
Very fast programming due to high-speed FPGA driven
hardware and support of IEEE1284 (ECP/EPP) high-speed
parallel port. Surely faster than competitors in this category.
T51prog interfaces with the IBM PC 486 compatible or higher,
portable or desktop personal computers. A programmer allows
you to directly connect to your PC through any standard
parallel (printer) port - no special interface card is needed.
T51prog has 40 powerful TTL pindrivers provide
H/L/pull_up/pull_down and read capability for each pin of
socket. Advanced pindrivers incorporate high-quality high-
speed circuitry to deliver programming without overshoot or
ground bounce for all supported devices. Pin drivers operate
down to 1.8V so you'll be ready to program the full range of
today's advanced low-voltage devices.
The programmer performs device insertion test (wrong or
backward position) and contact check (poor contact pin-to-
socket) before it programs each device. These capabilities,
supported by signature-byte check help prevent chip damage
due to operator error.
Programmer's hardware offers enough resources for selftest,
that control program is any time be able to check pindrivers,
present and correct level of all voltages, check the timing and
communication between programmer and PC.
78
To Next Page
Loading...