ELNEC s. r. o.
relative path to file that has to be
loaded, file format is detected
automatically
/Program[:switch] forces start of ”Program device”
operation automatically when program
is starting, or even if program is already
running, also one of following optional
switches can be used:
switch 'noquest' forces start of device programming
without question
switch 'noanyquest' forces start of device programming
without question and after operation on
device is completed, program doesn't
show "Repeat" operation dialog and
goes directly into main program
window
Examples:
1. /Program
2. /Program:noquest
3. /Program:noanyquest
/Close this parameter has sense together with
/Program parameter only, and makes
program to close automatically after
device programming is finished (no
matter if operation was successful or
no)
Hardware
Due a large variety of parallel port types, a case may occur
when the programmer cannot "get concerted" with the PC. This
problem may be shown as none communication between the
PC and the programmer, or by unreliable communication. If
this behaviour occur, try to connect your programmer to some
other PCs or other parallel ports near you.
If you find none solution, please document the situation, i.e.,
provide us an accurate description of your PC configuration,
including some other circumstances bearing on the problem in
question, and advise the manufacturer of your problem. Don’t
forget please enter of PC type, manufacturer, speed, operation
system, resident programs; your parallel port I/O manufacturer
and type. Use please Device problem report form for this
purpose (see Appendix A).
150
To Next Page
Loading...