ELNEC s. r. o.
Diagnostics / IC test
This command activates a test section for ICs separated by
compatibility to any libraries (on distribution CD). First select
an appropriate library, wished device and then a mode for test
vectors run (Loop, Single step). Control sequence and test
results are displayed to Log window.
Diagnostics / Create diagnostic report
Command Create Diagnostic report is used for writing more
particular diagnostic information to Log window and
consequently copy Log window content to clipboard. The Log
window content can be placed from clipboard to any text
editor. Diagnostic report is useful when error occurs in control
program or programmer and kind of the error is, that user can
not resolve it oneself and he must contact programmer
manufacturer. In this case when customer send message to
manufacturer about his problem it is good to send also
diagnostic report. Diagnostic report can help manufacturer to
localise the reason of error and resolve it sooner.
Help
Pressing the <F1> key accesses the Help. When you selecting
menu item and press <F1>, you access context-sensitive help.
If PG4UW is executing an operation with the programmer <F1>
generates no response.
The following Help items are highlighted:
• words describing the keys referred to by the current Help
• all other significant words
• current cross-references; click on this cross-reference to
obtain further information.
Detailed information on individual menu commands can be
found in the integrated on-line Help.
Since the Help system is continuously updated together
with the control program, it may contain information not
included in this manual.
Note: Information provided in this manual is intended to be
accurate at the moment of release, but we continuously
improve all our products. Please consult manual on
www.elnec.com.
146
To Next Page
Loading...