ELNEC s. r. o.
Other
Attention to multitasking OS's (Windows
95/98/Me/NT/2000/XP). There is needful for regular running of
control program for any ELNEC programmer that printer port,
on which is programmer connected, must be reserved for this
programmer only. Otherwise, any other program must not
simultaneously to use (or any way to modify) this printer port.
PG4UW SW can handle all modes of LPT port (full IEEE 1284
support), thus you don't need to configure LPT port for
connection of ELNEC programmers.
Please don't move any window during BUSY LED is on -
watching circuit can be activate to switch the programmer in
safe status as in case communication PC-programmer error.
160
To Next Page