Software
The menu command Device / Device options / Operation
options allows to set another working area as the standard.
Device / Read
This command allows reading whole device or its part into the
buffer. The control program reports a finish of this action by
write a message to INFO window.
The menu command Device / Device options / Operation
options allows to set another working area as the standard.
Setting an option Verify data after reading in this menu
command means a higher reliability for device reading.
Device / Verify
This command compares the programmed data of the all
device or its part with data in buffer. The control program
reports a result of this action by a write of an error message to
INFO window.
The menu command Device / Device options / Operation
options allows to set another working area as the standard.
By the setting in the menu Options / Display errors the
command lets to write the found errors on the display or write
the found errors to VERIFY.ERR file. In the Display errors
mode to the screen can display the program max. 45 the first
found differences, which are located by the address where
they were caused.
Device / Program
This command allows to programming of the all device or its
part by the data of the buffer. The control program reports a
result of this action by a write of an error message to INFO
window.
The menu command Device / Device options / Operation
options allows to set another working area as the standard,
and set other operation options for programming process
control.
Device / Erase
This command allows erasing the whole programmable device.
The program reports the end without error or end with the error
by writes the warning report on the display.
133
To Next Page
Loading...