ELNEC s. r. o.
Options / View / Device options before device
operation
Choose this command to enable/disable display of Device
options before device operation is confirmed.
Options / Display errors
This option allows you set a form of errors displaying as a
result of programmed data verifying. Errors can be displayed
to the screen (max. 45 differences), saved to VERIFY.ERR
file on the disk in current directory or it will not displayed. In
case the displaying errors are turned off, the control program
reports a warning message in INFO window only.
This setting can be saved to disk by command Options / Save
options. Default form is set to a screen displaying.
Options / Find programmer
Selects a new type of programmer and communication
parameters. This command contains following items:
Programmer - sets a new type of programmer for find. If a
Search all is selected, the control program finds all supported
programmers.
Establish communication - allows manual or automatic
establishing communication for a new programmer.
Speed - sets speed, if a manual establishing communication is
selected, which PC sends data into the programmer. Speed is
expressed as a percent from a maximal speed.
The communication speed modification is important for PCs
with "slow" LPT ports, which haven't sufficient driving power for
a PC<->programmer cable (laptop, notebook, ...). Use this
command, if you have any communication problems with
connected programmer on the LPT port of your PC (e.g.
control program reports a programmer absence, the
communication with the programmer is unreliable, etc.).
If automatic establishing communication is selected, then
control program sets a maximal communication speed.
Note: Items Establish communication and Speed are available
only for PREPROM-02aLV and SEEprog.
Port - selects a LPT port, which will be scanned for a
requested programmer. If All port is selected, the control
program scans all LPT ports, which are available on standard
addresses.
Address for special port - sets address of LPT port, if a
Special port is selected.
142
To Next Page
Loading...