BeeProg
• support all devices in DIP with default socket
• support devices in non-DIP packages up to 48 pins with
universal adapters
• programmer is compatible with third-party adapters for non-
DIP support
Programming speed
Note. These times strongly depend on PC speed, LPT port
type and operating system free resources. Therefore are given
values of two different PC configurations for comparison.
These times are only for illustration, for actual times see
www.elnec.com.
Device Operation Time A Time B Time C
27C010 programming and verify 24 sec 20 sec 24 sec
AT29C040A programming and verify 38 sec 28 sec 38 sec
AM29F040 programming and verify 49 sec 42 sec 49 sec
PIC16C67 programming and verify 8 sec 7 sec 8 sec
PIC18F452 programming and verify 13 sec 9 sec 13 sec
Time A conditions: Pentium MMX, 250 MHz, ECP/EPP,
Windows 98.
Time B conditions: Athlon, 750 MHz, ECP/EPP on PCI
bus, Windows 98.
Time C conditions: Athlon, 750 MHz, USB, Windows 98.
SOFTWARE
• Algorithms: only manufacturer approved or certified
algorithms are used. Custom algorithms are available at
additional cost.
• Algorithm updates: software updates are available approx.
every 2 weeks, free of charge.
• Main features: revision history, session logging, on-line help,
device and algorithm information
Device operations
• standard:
• intelligent device selection by device type, manufacturer or
typed fragment of part name
• automatic ID-based selection of EPROM/Flash EPROM
• blank check, read, verify
• program
• erase
• configuration and security bit program
• illegal bit test
• checksum
• security
• insertion test, reverse insertion check
• contact check
37
To Next Page
Loading...