ELNEC s. r. o.
signals applied to the target device and for reliable
communication with the PC.
LabProg+ incorporates optimal PCB design criteria to minimize
unwanted effects at the pins of the target socket (such as
ground-bouncing and supply/programming voltage glitches). All
the inputs of the LabProg+, including the socket, are protected
against ESD and whilst inserted the target device is also
protected against ESD damage.
LabProg+ performs programming verification at the marginal
level of supply voltage, which, obviously, improves
programming yield and guarantees long data retention.
LabProg programmer is driven by an easy-to-use control
program with pull-down menu, hot keys and on-line help.
Selecting of device is performed by its class, by manufacturer
or simply by typing a fragment of vendor name and/or part
number.
Standard device-related commands (read, blank check,
program, verify, erase) are boosted by some test functions
(insertion test, signature-byte check), and some special
functions (autoincrement, production mode - start immediately
after insertion of chip into socket).
All known data formats are supported. Automatic file format
detection and conversion during load of file.
The rich-featured autoincrement function enables to assign
individual serial numbers to each programmed device - or
simply increments a serial number, or the function enables to
read serial numbers or any programmed device identification
signatures from a file.
Various socket converters are available for the LabProg+,
DIL to PLCC, DIL to PSOP, DIL to SOIC, DIL to TQFP and DIL
to TSOP. Software controlled pin-swapping capability together
with universal converters are what give the LabProg+ the
ability to program the target device in any package type. For
example, just one DIL44 to PLCC44 converter will allow the
LabProg+ to handle any PLCC44 target device in the current
device list. Most devices with more than 48 pins require a
simple adapter usually available from ELNEC.
It is important to remember that in most cases new devices
require only a software upgrade since the LabProg+ has 48
true pin drivers, which can perform as required under program
control. With our prompt service new devices can be added to
the current list within hours!
42
To Next Page
Loading...