Elnec JetProg - Page 58

ELNEC s. r. o.
• Microcontrollers Scenix (Ubicom): SX18xxx, SX20xxx,
SX28xxx series
Programmer, through ISP connector
• Microcontrollers Atmel: AT89Sxxx, AT90Sxxxx, ATtiny,
ATmega series
• Microcontrollers EM Microelectronic: 4 and 8 bit series
• Microcontrollers Microchip PICmicro: PIC12Cxxx, PIC16C5x,
PIC16Cxxx, PIC17Cxxx, PIC18Cxxx series
Notes:
• (*1) - suitable adapters are available for non-DIL packages
• (*2) - there exist only few adapters for devices with more than
40 pins. Therefore think please about more powerful
programmer (JetProg, BeeProg, LabProg+), if you need to
program devices with more than 40 pins
• For all supported devices see actual Device list on
www.elnec.com.
I.C. Tester
• Static RAM: 6116 .. 624000
Programming speed
Note. These times strongly depend on PC speed, LPT port
type and operating system free resources. Therefore values of
two different PC configurations are given for comparison.
Device Operation Mode Time A Time B
27C010 programming and verify in ZIF 28 sec 24 sec
AT29C040A programming and verify in ZIF 38 sec 28 sec
AM29F040 programming and verify in ZIF 102 sec 87 sec
PIC16C67 programming and verify in ZIF 13 sec 11 sec
PIC18F452 programming and verify in ZIF 11 sec 9 sec
AT89C52 programming and verify in ZIF 18.5 sec 16.5 sec
PIC16F873A programming and verify ISP 7 sec 6 sec
PIC12C508 programming and verify ISP 11 sec 9 sec
Time A conditions: Pentium MMX, 250 MHz, ECP/EPP,
Windows 98.
Time B conditions: Athlon, 750 MHz, ECP/EPP on PCI
bus, Windows 98.
SOFTWARE
• Algorithms: only manufacturer approved or certified
algorithms are used. Custom algorithms are available at
additional cost.
• Algorithm updates: software updates are available approx.
every 2 weeks, free of charge.
• Main features: revision history, session logging, on-line help,
device and algorithm information
58