Elnec JetProg - Page 74

ELNEC s. r. o.
• EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx series,
with 8/16 bit data width, full support of LV series (*1*2)
• Flash EPROM: 28Fxxx, 29Cxxx, 29Fxxx, 29BVxxx, 29LVxxx,
29Wxxx, 49Fxxx series, with 8/16 bit data width, full support
of LV series (*1*2)
• Serial E(E)PROM: AT17Cxxx, 24Cxxx, 24Fxxx, 25Cxxx,
59Cxxx, 85xxx, 93Cxxx, NVM3060, MDA206x, full support of
LV series(*1)
• Configuration PROM: 17xxx series, LV series including (*1)
• NV RAM: Dallas DSxxx, SGS/Inmos MKxxx, SIMTEK
STKxxx, XICOR 2xxx, ZMD U63x series
Notes:
• (*1) - suitable adapters are available for non-DIL packages
• (*2) - there exist only few adapters for devices with more than
40 pins. Therefore think please about more powerful
programmer (JetProg, BeeProg, LabProg+), if you need to
program devices with more than 40 pins
• (*3) - programming with additional module
• For all supported devices see actual Device list on
www.elnec.com.
I.C. Tester
• Static RAM: 6116 .. 624000
Programming speed
Note. These times strongly depend on PC speed, LPT port
type and operating system free resources. Therefore values of
two different PC configurations are given for comparison.
Device Operation Time A Time B
27C010 programming and verify 28 sec 24 sec
AT29C040A programming and verify 38 sec 28 sec
AM29F040 programming and verify 102 sec 87 sec
Time A conditions: Pentium MMX, 250 MHz, ECP/EPP,
Windows 98.
Time B conditions: Athlon, 750 MHz, ECP/EPP on PCI bus,
Windows 98.
SOFTWARE
• Algorithms: only manufacturer approved or certified
algorithms are used.
• Algorithm updates: software updates are available approx.
every 2 weeks, free of charge.
• Main features: revision history, session logging, on-line help,
device and algorithm information
Device operations
• standard:
74