MagTek Device Drivers for Windows
14
Property Access Description
offline_enc
R/W
Set to
1 to enable encode capability in standalone mode with
keyboard; 0 prevents standalone encoding (MT-95).
oper_tout
R/W Operational timeout in seconds (15-255). (IntelliPIN)
pin_blk_fmt
R/W PIN block format (IntelliPIN):
ansi (ANSI 9.8) or ibm (IBM 3624)
pinfilldig
R/W
PIN fill digit (0..9, A..F) when
pin_blk_fmt is ibm (IntelliPIN)
port_name
R Indicates the virtual port number (e.g., COM6) derived from the
friendly port name.
pwroffdelay
R/W Power off time delay in minutes (5-255). (IntelliPIN)
s_down_tout
R/W
Shutdown timeout in hours (1-31). Set to
0 to disable. (IntelliPIN)
track1ss
track2ss
track2ss
R
R
R
Indicates Start Sentinel on Track 1 as received from the device.
Indicates Start Sentinel on Track 2 as received from the device.
Indicates Start Sentinel on Track 3 as received from the device.
trivpinchk
R/W
Set to
1 for trivial PIN checki.e., don’t allow 1234. (IntelliPIN)
trk_enable
R/W Enable reading and writing of individual tracks. The value of this
property is a string of three characters, with
0 representing
disabled tracks and 1 representing enabled tracks, e.g., 110 enables
tracks 1 and 2 and disables track 3.
trk1data
R Data from track 1 excluding start sentinel and end sentinel.
trk2data
R Data from track 2 excluding start sentinel and end sentinel.
trk3data
R Data from track 3 excluding start sentinel and end sentinel.
visa_mac1
visa_mac2
visa_mac3
R Message authentication codes returned by device after PIN is
collected (DUKPT mode only). (IntelliPIN)
wr_coer
R/W Encode Coercivity Mode (MT-95). Specifies the energy level used
to encode the magnetic stripe:
0 = automatic selection
1 = LoCo only mode
2 = HiCo only mode
wr_secure
R/W
0 indicates the card can be removed between a read and write
operation. Set this to 1 to turn on secure online encode mode (MT-
95).
xact_type
R/W
Transaction type –
d = debit, c = credit (IntelliPIN).
To Next Page
Loading...
Need help?
General
