Appendix A. Installation and Setup
59
Removing the Drivers (W95/98/ME)
Caution
The following assumes familiarity with the Registry Editor.
Improper use of the Registry Editor can cause Windows to cease to
function. Please follow the instructions carefully.
Complete removal of the drivers requires two steps: (1) remove the drivers from the system
using the Device Manager and (2) remove the driver files manually after all devices have been
removed by the Device Manager.
To remove the drivers, follow these steps:
1. Stop any applications that are using the drivers. This will insure that all of the ports that are
going to be removed are closed.
2. Right-click on My Computer on the desktop or open the Control Panel and double click on
the System icon then select Properties.
3. Select the Device Manager tab and click on the plus sign at MagTek.
4. Select the device under the MagTek group and click on Remove. Then click OK. After all
device drivers have been removed in this manner, go to step 5.
5. Using Explorer or some other file manager, remove the following driver VXDs from
C:\Windows\System:
GENERIC.VXD
IPIN.VXD
MAGWEDGE.VXD
MICRPLUS.VXD
MINIMICR.VXD
MINIWEDG.VXD
MT85.VXD
MT95.VXD
MTPPINSR.VXD
MTPPSWIP.VXD
The driver files may be removed only if no drivers are currently installed that require
them. In particular, the class driver (MAG-TEKCL.VXD) must remain if any device
type is still installed. The driver files may be removed when all devices of that particular
type have been removed.
6. Remove the support files from C:\Windows\System\. The support files are:
DMAPLD.VXD
DMVXD.VXD
DMVXDD.VXD
MAG-TEKCL.DLL
MAG-TEKCL.VXD
MAGCDFLT.HLP
To Next Page
Loading...
Need help?
General
