53
APPENDIX A. INSTALLATION AND SETUP
The distribution disks contain the MTD Driver files for many of the MagTek products. In
addition to the drivers, there are number of files that are required to support the installation and
operation of these drivers. The disk contents are listed in the tables below.
Some of the Drivers support multiple configurations of the associated product. For example, the
IntelliPIN Driver (IPIN.VXD) provides an interface vehicle for three different interface
configurations. When a Driver is installed, be sure to select the proper interface type for your
installation.
After installing a driver, you will be given the option of adjusting the Port Name (virtual port)
and the Connect to (physical port) values. The Port Name is the COMxx port by which the
device will be addressed. The Connect to is the port that the device is physically attached to on
the PC.
To Next Page
Loading...
Need help?
General
