MagTek Device Drivers for Windows
68
and MTD device will appear as COM7. The MICR+ device appears to the system as COM12
and has a friendly name : MICR+.) Two examples are shown:
mtcfg COM7 "IntelliPIN MICR Aux" "UsePort=AUX port on MICR+"
"FriendlyName=IntelliPIN AUX"
or
mtcfg COM7 "IntelliPIN MICR Aux" "UsePort=AUX port on COM12"
"FriendlyName=IntelliPIN AUX"
Viewing the List of Configured Devices (WNT/2000/XP)
Execute MTCFG with no command line arguments. If the above examples have been used, the
displayed result will be:
port Conn. to model friendly name
COM5 MiniWedge MiniWedge
COM6 COM1 Mini MICR RS-232 Mini MICR RS-232
COM7 AUX port on MICR+ IntelliPIN MICR Aux IntelliPIN AUX
Using the MTCFG Utility (WNT/2000/XP)
MTCFG.EXE is a command-line utility installed with the MTD drivers. It requires that the driver
binaries be correctly installed, as described in the previous sections. MTCFG cannot be used to
install the driver binaries; running it from the installation media before the driver has been
installed will result in the following error message:
Mag-Tek driver is not correctly installed. Please install the driver
before using this program.
The same message will be displayed if the installation has been modified manually, e.g., the
installation script has been renamed or removed or the driver’s Registry data has been removed.
It is recommended that all applications that may have opened a MagTek device be terminated
before using MTCFG to change a device’s configuration, or to add or remove a device.
To Next Page
Loading...
Need help?
General
