Eloma BACKMASTER EB 30 - Clearing Faults and Malfunctions; Possible Causes of Fault and Remedy

Clearing faults and malfunctions
65
8 CLEARING FAULTS AND
MALFUNCTIONS
NOTE
If the signal display or an audible signal tone indicates a fault, the device
may be faulty.

Switch off the device and/or disconnect it from the power.

The operator can carry out the first fault analysis based on the following
table. You can also inform Eloma's customer service department to ask
for help.

If the operator is unable to clear the fault, or if there is a technical fault,
a service technician will need to be informed to carry out fault clearance
.
8.1 POSSIBLE CAUSES OF FAULT AND REMEDY
Malfunction
Possible cause
Troubleshooting
The device does not
display a function after
switching on.
The external master
switch has been
switched off.

Switch on the
master switch.
A fuse or circuit breaker
has triggered.

Check the fuses or
circuit breakers in
the building's
distribution.
Ambient temperature of
the device was below +4
°C for a longer period.

Heat the cooking
chamber to 20 °C.

Only operate the
device in rooms
which are protected
from frost.
No steam injection Water connection is
closed.

Open the water
connection.
The water in the baking
chamber does not drain
off.
Faulty device or steam
injection quantity too
high although set
correctly beforehand.

Reduce the steam
injection quantity.

Inform the
customer service
department.
No light in the baking
chamber
The halogen lamps are
faulty.

Replace the
halogen lamps.