Eloma Genius compact - Operational Safety Hints

36
13. Hints on operational safety
Please do observe carefully the detailed installation instructions.
Only approved Eloma cleaning agents may be used.
All safety devices inside the unit have been designed to the use of these products in order to
comply with the standard specifications of the drinking water supply.
Other cleaning products can possibly cause irreparable rust damages in the cooking chamber, as
well as damage pumps and seals.
Eloma GmbH cannot assume liability for any damages resulting from the use of alternative
products. This will void the Eloma warranty.
Regular maintenance on all types of water treatment and compliance with the manufactures
recommendations need to be adhered to at all time. Should water treatment and cleaning agents
not comply to the Eloma standard this will affect any possible warranty claims.
Do not use flammable liquids for cleaning the appliance.
Exchange of canisters and refilling of cleaner and rinse agent.
Observe the directions of the manufacturer and wear suitable protective clothing, gloves and glasses.
For safety reasons, the door must not be opened during an autoclean program.
Cleaner, rinse agent, hot water and steam may escape. If it is absolutely necessary to open
the door, the autoclean program must be stopped.
If the oven is not used for an extended period of time, rinse the whole Autoclean
system thoroughly with lukewarm water to avoid clogging caused by cleaner and
rinse-agent remainders.
Remove screwings from the canisters and clean the tube ends and the filter in warm water.
Start autoclean step Flushing and rinse the appliance until no more cleaner is remaining
inside the tubes and the cabinet.
Preparation for cleaning
Prior to starting a cleaning program make sure that there is sufficient cleaner and rinse agent in the
respective canisters. Visual control.
No food products should be in the cooking chamber.
Exchange of canisters
In case there is not sufficient cleaner or rinse agent left, the canisters must be exchanged or refilled.
Please ensure that correct connections are made.
 Select autoclean with the sensor key Special Programme, and confirm with OK.
 Use the Scout arrow keys  and  to select operation and start with
.
 Autoclean is ready for use.