ELTEX SBC-1000 - Page 129

SBC session border controllers 129
SIP_DESTINATION_NAME
SIP_TRANSPORT_ID
SIP_REMOTE_IP_ADDR
String, 63
characters max.
1-65535
AAA.BBB.CCC.DDD/
AAA.BBB.CCC.DDD:port
where
port = 1-65535
Set the name.
Set ID for the used SIP transport
Oncoming side IP address and port. If
no port is specified, port 5060 will be
used.
edit destination
id
PREFIX_SIGN
0-65534
Edit destination with selection by ID
edit destination
index
PREFIX_SIGN
1-65535
Edit destination with selection by index
exit
Exit from this configuration submenu to
the upper level.
quit
Terminate this CLI session
remove
destination
SIP_DESTINATION_INDEX
0-254
Remove destination by index
remove by id
destination
SIP_DESTINATION_ID
1-65535
Remove destination by ID
show info
Show list of all destination
show sip
transport list
Show list of transports
4.2.7.18 SIP destination configuration
To enter this mode, in the SIP destination list configuration mode, execute the edit destination
<ID> or edit destination index <INDEX> command, where <ID> and <INDEX> — ID or index of the
edited destination.
SBC1000-[CONFIG]-SIP-DESTINATION> edit destination id 12
Entering SBC SIP destination edit mode.
SBC1000-[CONFIG]-SIP-DESTINATION-ID[12]>
Command
Parameter
Value
Action
?
Show the list of available commands.
exit
Exit from this configuration submenu to
the upper level.
quit
Terminate this CLI session
set adaptation
ADAPTATION
none/
HUAWEI-EchoLife/
Iskratel-SI3000/
HUAWEI-SoftX3000/
ZTE-Softswitch/
Nortel/
MTA-M-200
Set the adaptation for this direction
set allow
redirection
ON_OFF
on/off
Management of permissions for
handling redirects
set auth login
AUTH_LOGIN
String, 63
characters max.
Authentication login
set auth
password
AUTH_LOGIN
String, 63
characters max.
Authentication password
set auth remove
Clear authentication settings
set command line
CMDLINE
String
Set the advanced SIP settings rules
set const fromto
domain
ON_OFF
on/off
Managing the «Pass the domain from
FROM and TO headers» option
set convert
flash
ON_OFF
on/off
Enable or disable conversion of Flash
from RFC2833 to SIP INFO
set cps in
<MAX_CPS_IN>
0-100
Incoming maximum CPS value; 0 —
option disabled
set cps out
<MAX_CPS_OUT>
0-100
Outgoing maximum CPS value; 0 —
option disabled