ELTEX SBC-1000 - Configuration Application and Confirmation Commands; Other Commands

176 SBC session border controllers
show candidate-config
Syntax
show candidate-config
Parameters
Command contains no arguments.
Command mode
CONFIG – SWITCH
Configuration application and confirmation commands
Once the SBC-2000 switch has been configured, you must apply the configuration (apply) to make it active on the
device and confirm the application (confirm) to protect against the changes that have been made causing loss of
access to the device. If no confirmation is performed within 60 seconds, the configuration is rolled back to the
previous running-config.
Configuration application command.
Syntax
apply
Parameters
Command contains no arguments.
Command mode
CONFIG – SWITCH
Confirmation command.
Syntax
confirm
Parameters
Command contains no arguments.
Command mode
CONFIG – SWITCH
Other commands
config
Command to return to the Configuration menu.
Syntax
config
Parameters
Command contains no arguments.