ELTEX SBC-1000 - LLDP Configuration

166 SBC session border controllers
Default value
Switching disabled.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> backup-interface preemption
show interfaces backup
This command allows viewing interface redundancy settings.
Syntax
show interfaces backup
Parameters
Command contains no arguments.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> show interfaces backup
Backup Interface Options:
Preemption is disabled.
MAC recovery packets rate 400 pps.
Recovery packets repeats count 1.
Backup Interface Pairs
~~~~~~~~~~~~~~~~~~~~~~
VID Master Interface Backup Interface State
---- ------------------------- ------------------------- ------------------------------
30 front-port 1/0 front-port 2/0 Master Up/Backup Standby
---- ------------------------- ------------------------- ------------------------------
150 front-port 1/0 front-port 2/0 Master Up/Backup Standby
LLDP configuration
lldp enable
This command allows the switch to work over the LLDP.
The use of a negative form (no) of the command disables LLDP protocol usage by switch.
Syntax
[no] lldp enable
Parameters
Command contains no arguments.
Command mode
CONFIG SWITCH