ELTEX SBC-1000 - Configuration Mode

SBC session border controllers 109
Configuration mode
4.2.7.1 General device parameter configuration mode
To proceed to device parameter configurations/monitoring, execute config command.
SBC> config
Entering configuration mode.
SBC-[CONFIG]>
Command
Parameter
Value
Action
?
Show the list of available commands.
alarm show
View alarm display settings
alarm set cps
invite/other/subsc
ribe
yes/no
Change the INVITE/OTHER/SUBSCRIBE
request processing limit alarm display
mode
alarm set cpu
<set>
yes/no
Change the high CPU load alarm display
mode
alarm set fans
<set>
yes/no
Change the fan alarm display mode
alarm set ram
<set>
yes/no
Change the RAM occupancy alarm
display mode
alarm set rom
<set>
yes/no
Change the ROM occupancy alarm
display mode
alarm set reserve
<set>
yes/no
Change the reserve alarm display mode
autoupdate
Switching to the configuration mode of
automatic firmware and configuration
updates
copy
running_to_startup
Write the current configuration into
non-volatile memory of the the device
(into start configuration)
copy
startup_to_running
Restore the current configuration from
the start configuration
dos-protection
Enter the DoS protection configuration
mode
firewall dynamic
Enter the dynamic firewall configuration
mode
firewall static
Enter the static firewall configuration
mode
global set
Invite-per-3-
sec/other-per-3-
sec/subscribe-per-
3-sec
<INVITE/OTHER/SUBS
CRIBE_RESTRICT>
60-300
INVITE/OTHER/SUBSCRIBE requests
processing restriction
global set media-
security-timeout
<SECURITY_TIMEOUT>
1-10080
Protective timeout for rejection of calls
without media, min
global set not-
encode-hash
yes/no
Enable the option to pass the «#»
character without encoding
history
View history of entered commands.
hostping
Switching into the ping utility operation
mode
log path
<apply>
<set>
<show>
local
/mnt/sd[abc][1-7]*
Apply settings of path to trace storage.
Configuration of path to trace storage:
local — local storage in RAM;
/mnt/sd[abc][1-7]* — path to the trace
storage drive
View settings of path to trace storage
network
Enter the network parameter
configuration mode