36 SBC session border controllers
4 DEVICE CONFIGURATION
There are four ways to connect to the device: via web configurator, Telnet, SSH or via cable via RS-232 (access
via RS-232, SSH or Telnet uses the CLI command console).
To save changes made to configuration into the non-volatile memory, use «Service/Save
configuration to flash» menu in the web configurator or the copy running to startup
save command of CLI.
4.1 SBC configuration via web configurator
To configure the device, establish connection using a web browser (hypertext viewer), e.g. Google, Firefox,
Internet Explorer, etc. Enter the device IP address in the browser address bar:
SBC factory default IP address — 192.168.1.2, network mask—255.255.255.0
After entering IP address the device will request username and password. You can also select an interface
language.
When starting up for the first time, use username: admin, password: rootpasswd.
After accessing the Web Configurator, the 'System info' menu will open.
The Figure below shows web configurator navigation elements.
To Next Page
Loading...