ELTEX SBC-1000 - Sbc-3000

SBC session border controllers 15
SBC-3000
Session border controller SBC-3000 has a metal case available for 19” form-factor rack-mount 1U shelf installation.
The front panel of device is shown in the Figure below.
Figure 8 — The front panel of SBC-3000 (based on SMG-3016)
Connectors, LEDs and controls located on the front panel of the device are listed in Table 6.
Table 6 — Description of connectors, LEDs, and controls located on the front panel
№
Front panel elements
Description
1
SATA disk ports
Cradle connectors for SATA drive installation
2
Console
Console port for local management of the device
3
OOB
Dedicated Ethernet port for device configuration
1
. The port does not
have the ability to switch with other SMG ports
4
F
Function button
5
USB
USB ports for external storage devices connection
6
1, 2
2 x 10/100/1000BASE-T Gigabit uplink interface RJ-45 connectors
used for IP network connection
7
3, 4
2 chassis for 1000BASE-X uplink interface SFP modules used for IP
network connection
2 x 10/100/1000BASE-T Gigabit uplink interface RJ-45 connectors
used for IP network connection
8
E1 Line 0..15
16 x RJ-48 connectors for E1 streams
2
9
Sync.1, Sync.2
2 x RJ-45 ports for connection of external synchronization sources
2
Indicators
10
Alarm
Device alarm indicator
Status
Device operation indicator
Sync.1
Sync.2 external synchronization interface operation indicator
2
Sync.0
Sync.1 external synchronization interface operation indicator
2
Power
Device power indicator
RPS
Device aux power indicator
1
Not supported in the current firmware version
2
Not used for configuration SBC-3000