ELTEX SBC-1000 - VLAN Interface Management Commands; STP;RSTP Configuartion Commands

SBC session border controllers 155
VLAN interface management commands
pvid
This command sets the default VID value for packets received by the port.
When an untagged packet or a packet with VID value in the VLAN tag equal to 0 is received, the packet is assigned
a VID value equal to PVID.
Syntax
pvid <num>Parameters
<num> — VLAN port ID number, specified in the range [1 ... 4094].
Default value
PVID = 1
Command mode
INTERFACE FRONT-PORT
INTERFACE PORT-CHANNEL
Example
SBC-2000-[CONFIG]-[SWITCH]-[if]> pvid 5
PVID 5 is assigned to the configured port.
STP/RSTP configuartion commands
spanning-tree enable
This command enables the STP function on the interface to be configured.
The use of the negative form of the command (no) forbids STP on interface.
Syntax
[no] spanning-tree enable
Parameters
Command contains no arguments.
Command mode
INTERFACE FRONT-PORT
INTERFACE PORT-CHANNEL
Example
SBC2000-[CONFIG]-[SWITCH]-[if]> spanning-tree enable
The STP feature is enabled for all front-port.
spanning-tree pathcost
This command sets the value of the STP path for the configurable interface.
The use of a negative form (no) of the command sets the default path cost value.
The default value is 0.