ELTEX SBC-1000 - Network Utilities

86 SBC session border controllers
 QoS 802.1p priority settings—allows distributing packets into queues depending on the 802.1р priority.
 802.1р — 802.1р priority value;
 Queue — egress queue number.
 Diffserv queue mapping — allows distributing packets into queues depending on the IP diffserv priority.
 diffserv — IP diffserv priority value;
 Queue — egress queue number.
 Apply — apply defined settings;
 Confirm — confirm modified settings;
Click 'Confirm' button in 1-minute interval to confirm settings, or the previous values will be
restored.
 Default — set default settings;
 Save — save settings into the device flash memory without applying them.
Network utilities:
4.1.7.1 PING
This utility is used for device network connection (route presence) check.
Network utilities –> PING
IP Probing — used for a single-time device network connection control.
To send an echo request (Ping), enter host IP address or network name in the 'IP probing' field and click the
'Ping' button. Command execution result will be shown in the lower part of the page. The result contains the
quantity of transmitted packets, quantity of received responses to those packets, percentage of lost packets, and
reception/transmission time (minimum/average/maximum) in milliseconds.