SBC session border controllers 147
Possible value: 1.
– sm-port — internal ports of the SBC-2000 switch designed to communicate with SM-VP
submodules.
Possible values: 0 – 5.
When working with the switch, a unit number value of 1 is used.
SBC-2000 switch interface management commands
interface
This command allows entering the configuration mode of the SBC-2000 switch interfaces.
Syntax
interface <interface> <number>
Parameters
<interface> — interface type:
front-port — external switch interfaces;
host-channel — LAG host-channel interfaces aggregation groups of the switch;
port-channel — LAG aggregation groups of the switch's external interfaces;
<number> — port number:
for front-port: <unit/port>, where
unit — SBC-2000 module number, always is 1;
port — port number, may take values: [0 .. 3];
for host-channel: 1;
for port-channel: [1 .. 4].
The <number> parameter can take the 'all' value to configure all ports of the same interface type at once.
shutdown
This command disables an interface being configured.
The use of a negative form of the command enables the interface being configured.
Syntax
[no] shutdown
Parameters
Command contains no arguments.
Example
SBC2000-[CONFIG]-[SWITCH]-[if]> shutdown
The configurable interface disabled
bridging to
This command sets permission for traffic transfer between interfaces.
The use of the negative form of the command sets prohibition for traffic transfer between interfaces.
To Next Page
Loading...