SBC session border controllers 31
Figure 23 — Fan connection socket in SBC-1000 based on SMG-1016M
To install a ventilation unit, perform the following actions:
1. Connect the unit to the socket.
2. Insert the unit into the case.
3. Screw the ventilation unit to the rear panel.
SSD installation for SBC-1000
Figure 24 — SSD installation procedure
Figure 25— SSD mounting procedure
1. Check if the device is supplied with power.
2. If yes, disconnect the power supply.
3. Remove the device from the rack if necessary (see Section 2.11.3).
To Next Page
Loading...