ELTEX SBC-1000 - Page 131

SBC session border controllers 131
set trunk
username/number
USERNAME_NUMBER
String, 63
characters max.
The user name used for registration
set verify media
remote address
ON_OFF
on/off
Enable the RTP source IP and port
control option
show info
Show settings
show rule set
list
Show list of configured rule set
show sip
transport list
Show list of available SIP transports
4.2.7.19 SIP transport configuration
To enter this mode, execute 'sip transport' command in the SIP transport list configuration mode.
SBC1000-[CONFIG]> sip transport
Entering SBC SIP transport mode.
SBC1000-[CONFIG]-SIP-TRANSPORT>
Command
Parameter
Value
Action
?
Show the list of available commands.
add transport
SBC_SIP_TRANSPORT_NAME
IFACE_ID
PORT
RTP_IFACE_ID
String, 63
characters max.
1-65535
1-65535
1-65535
Add new SIP transport.
Set the name.
Set the ID of the interface used for SIP
signaling
Set the port for signalling
Set the ID of the interface used for RTP
exit
Exit from this configuration submenu to
the upper level.
quit
Terminate this CLI session
remove transport
SBC_SIP_TRANSPORT_INDE
X
0-254
Remove destination by index
remove by id
transport
SBC_SIP_TRANSPORT_ID
1-65535
Remove destination by ID
set by id name
SBC_SIP_TRANSPORT_ID
SBC_SIP_TRANSPORT_NAME
1-65535
String, 63
characters max.
Change the name of the transport by its
ID
Transport ID
New transport name
set by id
netiface
SBC_SIP_TRANSPORT_ID
IFACE_ID
1-65535
1-65535
Change the network interface for SIP
signalling
Transport ID
Network interface ID
set by id port
SBC_SIP_TRANSPORT_ID
PORT
1-65535
1-65535
Change the port for signalling
Transport ID
Port for signalling
set by id rtp
SBC_SIP_TRANSPORT_ID
RTP_IFACE_ID
1-65535
1-65535
Change the network interface for RTP
Transport ID
Network interface ID
set name
Change the name of the transport by its
ID