SBC session border controllers 171
[number] — port number (you can specify several ports separated by commas «,» or you can specify the
range of ports with «-»).
for front port: <unit/port>, where:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 3];
for port-channel: [0 .. 4].
Default value
The display will show information for all ports.
Command mode
CONFIG SWITCH
Example
SBC2000-[CONFIG]-[SWITCH]> show lldp local
LLDP local TLVs
~~~~~~~~~~~~~~~
Interface Device ID Port ID TTL
---------------- ---------------------- ----------------------- ----------
front-port 1/1 02:00:04:88:7c:0a front-port 1/1 120
front-port 1/2 02:00:04:88:7c:0a front-port 1/2 120
show lldp statistics
This command allows viewing LLDP statistics for front-port, port-channel interfaces.
Syntax
show lldp statistics [<interface>< number >]
Parameters
Optional parameters, if you omit them, the display will show information for all ports.
[interface] — interface type:
front-port — external uplink interfaces;
port-channel — external LAG uplink interface aggregation groups.
[number] — port number (you can specify several ports separated by commas «,» or you can specify the
range of ports with «-»).
for front port: <unit/port>, where:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 3];
for port-channel: [0 .. 4];
for slot-channel: [0 .. 15].
Default value
The display will show information for all ports.
Command mode
CONFIG SWITCH
To Next Page
Loading...