SBC session border controllers 83
4.1.6.3 802.1q
In '802.1q' submenu, you may define the configuration of packet routing rules for switch operation in 802.1q
mode. The table may contain up to 1024 characters.
Gateway switch is equipped with 3 electrical Ethernet ports, 2 optical ports and 1 port for CPU interactions:
– GE port 0, port 1, port 2 — electrical Ethernet ports of the device;
– CPU port — an internal port connected to the device's CPU;
– SFP port (0, 1) — optical Ethernet ports of the device.
Network switch –> 802.1q
Adding records to the packet routing table
– VID — enter the ID of the VLAN group for which the routing rule is being created and for each port assign
the actions it performs when transmitting a packet with the specified VID.
– unmodified — packets are transmitted with no changes (i.e. in the same form as they were received);
– untagged — packets will always be sent without VLAN tag by this port;
– tagged — packets will always be sent with VLAN tag by this port;
– not member — packets with specified VID are not transmitted by this port, i.e. the port is not a
member of this VLAN group.
Then, click «Add» button. To apply the configuration, click the «Apply» button, then confirm the settings with
the «Confirm» button.
Click 'Confirm' button in 1-minute interval to confirm settings, or the previous values will be
restored.
It is possible to save the settings to the Flash memory of the device without using the «Save» button.
Removing records from the packet routing table
To remove records, select checkboxes for the rows to be removed and click «Remove selected» button.
To Next Page
Loading...