SBC session border controllers 93
Firewall profiles
Security –> Static firewall
To create, edit or remove a firewall profile, use «Objects»
— «Add object», «Objects» — «Edit object» and «Objects» —
«Remove object» menus and the following buttons:
– «Add»;
– «Edit»;
– "Delete".
Software allows you to configure firewall rules for incoming, outgoing and transit traffic as well as for specific
network interfaces. The total number of firewall rules is the same for all profiles and is 1000 rules.
Security –> Static firewall –> «Add»
When a rule is created, you should configure the following parameters:
– Name — rule name;
– Enable — defines whether the rule will be used. When unchecked, the rule will be inactive.
– Traffic type — type of traffic for the rule being created:
– Ingress — intended for SBC;
– Egress — transmitted by SBC;
– Rule type — may take values:
– General — rule with IP and port verification;
– GeoIP — rule with GeoIP address verification;
– String — rule with a string occurrence in the package verification.
To Next Page
Loading...