30 VoIP Subscriber Gateways
When VoIP service is enabled, VoIP application will use VoIP service configuration for its
operation. If VoIP service is disabled then VoIP application use Internet network configuration for
operation.
Management service name does not mean that it can be used only for device management. The
service can be used for various user needs. However, if TR-069 client is run up on the device, it will use
Management service configuration for its operation. If the service is disabled, TR-069 client uses
Internet configuration for its operation.
Internet – key service, it cannot be disabled. The rest of the
services are additional and can be disabled.
To configure or check service settings, click corresponding button at the top of ‘Network
settings’ page.
It is important to know that you cannot use the same VLAN IDs for different services.
It is important to avoid the presence of the same subnet IP addresses (within one service
as well as several services) on different network interfaces.
The ‘Network settings’ submenu. Internet service
WAN settings – use this field for WAN interface settings.
Connection mode – select connection method to WAN from the drop down list (option is
available for configuration only in Internet):
- Wired connection – Internet connection is performed only through Ethernet-cable by
using WAN port;
- Wireless connection only (3G/4G) – Internet connection is performed via wireless USB
3G/4G modem (via mobile telephone network). To configure modem, you should click
link ‘Setup 3G/4G USB modem’;
- Switch to reserve channel automatically – Internet connection is performed via key
channel (it is assigned in the main submenu in the ‘Preferred channel’ field) and
automatic transfer will be performed via backup channel in case of vanishing the
Internet access via main channel.
To configure USB-modem, click the ‘Setup 3G/4G USB modem’ link.
To Next Page
Loading...
