41 VoIP Subscriber Gateways
2.2.2 The ‘IPSec’ submenu
In this submenu, you may configure IPSec encryption (IP Security). IPSec is a set of protocols
used for protection of data transmitted via Internet Protocol that enables authentication, integrity
check and/or encryption of IP packets. IPsec also includes secure Internet Key Exchange protocols.
IPSec settings:
- IPSec enable IPSec enable – permit to use IPSec protocol for data encryption;
- Name of service – service selection where encryption via IPSec protocol will be used;
- Local IP address – the device address for operation via IPSec protocol;
- Local subnet in cooperation with Local netmask determine local subnet for creation
network-to-network or network-to-point topology;
- Remote subnet in cooperation with Remote netmask determine address of remote
subnet for connection with using encryption via IPSec protocol. If the mask value is
255.255.255.255, communication is performed with a single host. Mask that differs from
255.255.255.255 allows defining a whole subnet. Thus, functionality of the device allows
To Next Page
Loading...
