38 VoIP Subscriber Gateways
- Enable WLAN DHCP-server (Local DHCP-server) – when checked, host connecting via Wi-
Fi to TAU-8.IP-W can get IP address, subnet mask and other parameters (that are
required for work in network) from a built-in DHCP server automatically.
Access configuration – use this section to set permission for access to the device via Web-
interface and via Telnet, FTP and SSH protocols.
- WAN access – to enable access to the device from external network, you should set the
flag opposite to the required connection: Web, Telnet, FTP, SSH and SNMP;
- WLAN access – only for TAU-8.IP-W devices – to enable access to the device from
wireless network, you should set the flag opposite to the required connection: Web,
Telnet, FTP, SSH и SNMP.
Common settings – use this section to set parameters that are applied to all the services
configured on the device.
- 1st DNS server, 2nd DNS server – server addresses of domain names (it is used for host
IP address determination by using its domain name). These fields can be empty, if they
are not required;
- Run Local DNS-server – when checked, local DNS server is enabled otherwise it is
disabled. Option is applied only to the TAU-8.IP-W devices. Local DNS server operates on
the side of the device wireless interface. When option is enable, local DHCP server as a
DNS address get WLAN interface address to the users. It is recommended to leave this
option on;
- IGMP Proxy – when checked, IGMP Proxy is enabled (necessary for IPTV operation).
Option is available only for TAU-8.IP-W devices;
By default, gateway is used only for static installation method of IP address on WAN
interface.
- WAN MAC address – МАС address of WAN interface;
- Speed and duplex – selection of speed and operation mode for duplex.
In case of using a gateway in private network, it is recommended to set IP address from allowed
RFC1918 range for this type of networks:
10.0.0.0 – 10.255.255.255
172.16.0.0 – 172.31.255.255
192.168.0.0 – 192.168.255.255
Check internet connection availability: these settings are used for checking the activity of
preferred channel during the selection of automatic switch to the backup channel in Internet service.
To Next Page
Loading...
