90 VoIP Subscriber Gateways
- Enable group – when checked, serial group is enabled otherwise call to the serial group
is impossible;
- Group name – identification group name;
- SIP profile – SIP profile used by serial group;
- Phone – group phone number;
- User Name – user name for authentication on SIP server;
- Password – password for authentication on SIP server;
- Call queue size – setting allows you to limit maximum number of unanswered calls in call
group. Incoming calls will be put in queue if it has free ports and if serial group does not
have free ports.
- Call reply timeout, sec – if group call is not answered, it will be dropped after timeout
expiration (calling subscriber receives ‘busy’ signal);
- SIP Port of group – alternative SIP port of group (the default value is 5060);
- Group call pickup enable – when checked, group call interception is permitted. Call
interception is available only if call group subscribers belong to the same group SIP
profile;
- Ports – to add port into serial group, click the preferred port in the ‘Available’ list and
drag it to the ‘Added’ list. Take into account that the order of ports is important because
of searching free port will be performed from the top of the list downwards (the top
port of the list will be called as first).
To add new group, click ‘Save’. To cancel adding a new group, click ‘Cancel’ button.
To edit record in ‘Action’ column of ‘Hunt group’ table, click button. To delete - on the icon
.
To store settings into the non-volatile memory, click Apply button.
Changes in this submenu take effect immediately after clicking the 'Apply' button. Device
reboot is not required.
To Next Page
Loading...
Need help?
General
