User Manual QT250 and QT800 gen 2.5, ID 2021 2.3 20. April 2021
• Project and engineering personnel
• Installation personnel
• Operators
• Supervisors
• Technical support personnel
• Technical management personnel
The following notations have been used in this manual:
Bold is used for commands and menu selection.
Italic is used to emphasize information. It is also used for names of documents
referred to in the manual.
Note! A note is used to draw attention to important or helpful information
A warning is used to draw attention to information of very high
importance, for example, to avoid injuries to personnel.
This User Manual QT250 and QT800 gen 2.5 are related to the following
documentation:
Table 3: Related documentation
Eltorque Hybrid Cable datasheet
Eltorque document ID 1982
Eltorque document ID 1687
Guidelines for earthing in maritime
installations
Published by the Norwegian Electrical
Safety Directorate. Available on the
internet or supplied by Eltorque on
request.
System Integrators Manual CANopen
Eltorque document ID 1691
The information contained in this document is subject to change without prior
notice. Eltorque AS shall not be liable for errors contained herein or for incidental
or consequential damages about the furnishing, performance, or use of this
document. It is the customer’s responsibility to verify that he has the latest
revision available by checking the document area of www.eltorque.no
Caution! Caution is used when there is a danger that the equipment is damaged if
you do not follow the instructions.
To Next Page
Loading...
