Figure 11: Bus connection of actuators
The Eltorque Hybrid Marine Cable combines signal and power cable in a hybrid
cable with maritime type approval. The cable can only be used for installations
with CANopen communication interface box. When this cable is used, only two
cable glands are required, see Chapter 8 Ordering Information and
Recommended Spare Parts.
Figure 12: Hybrid Marine Cable
Further description of the Hybrid Marine Cable is found in the Hybrid Marine
Cable datasheet, Eltorque document ID 1982. The datasheet is available on
www.eltorque.no – Products – System components.
With traditional cabling, four cable glands are required to accommodate both
power and signal cables. When ordering please inform if you intend to use the
Hybrid Marine cable or a standard cable.
The actuator can freely be mounted both vertically standing or horizontally lying
to the side. An upside-down hanging position should be avoided.
To Next Page
Loading...
