20
Celerra Network Server Command Reference Manual
The cel and cs Commands
rw_servers= server_2
ro_servers=
rw_vdms =
ro_vdms =
size = total = 22660 avail = 22659 used = 0 ( 0% ) (sizes in MB)
volume: total = 23012 (sizes in MB)
stor_devs =
002804000190-0034,002804000190-0035,002804000190-0036,002804000190-0037
disks = d3,d4,d5,d6
disk=d3 stor_dev=002804000190-0034 addr=c0t3l8-15-0 server=server_2
disk=d4 stor_dev=002804000190-0035 addr=c0t3l9-15-0 server=server_2
disk=d5 stor_dev=002804000190-0036 addr=c0t3l10-15-0 server=server_2
disk=d6 stor_dev=002804000190-0037 addr=c0t3l11-15-0 server=server_2
Where:
EXAMPLE #3 To extract a file system definition for ufs1 from cs30, type:
$ cel_fs cs30 -Extract ufs1
0:bofs:18
18:ufs1:0:y:1:164:1::::0:::
164:mtv1:0:y:3:2:18:156:
156:stv1:0:y:2:1:164:64:3,4,5,6:
6:d6:0:y:4:1:156:6:
6:d6:0:y:5753:002804000190:1,2,3,4:6:0037:5:
5:d5:0:y:4:1:156:5:
5:d5:0:y:5753:002804000190:1,2,3,4:5:0036:5:
4:d4:0:y:4:1:156:4:
4:d4:0:y:5753:002804000190:1,2,3,4:4:0035:5:
3:d3:0:y:4:1:156:3:
3:d3:0:y:5753:002804000190:1,2,3,4:3:0034:5:
0:eof:18
Where: The output is the extracted file system definition.
Value Definition
id ID of a file system (assigned automatically).
name name of the imported file system.
acl access control value for a file system. See nas_fs.
inuse whether a file system has been registered into the mount table.
type what type of file system. See nas_fs.
volume name of the volume on which a file system resides.
pool storage pool for the file system.
rw_servers servers with read-write access.
ro_servers servers with read-only access.
rw_vdms VDM servers with read-write access to a file system
ro_vdms VDM servers with read-only access to a file system.
size total size, available size, and amount used in MB.
volume volume size that is used.
stor_devs ID of the storage system device and the serial number.
disks the disks on which a file system resides - dd indicates a remote disk.
To Next Page
Loading...
Need help?
General
