366
Celerra Network Server Command Reference Manual
The server Commands
server_ifconfig
Manages the network interface configuration for the specified Data
Mover(s).
SYNOPSIS
server_ifconfig {<movername> | ALL}
-all
| -delete <if_name>
| -create -Device <device_name> -name <if_name>
-protocol {IP <ipaddr> <ipmask> <ipbroadcast>}
| <if_name> [up | down | mtu=<MTUbytes> | vlan=<vlanID>]
DESCRIPTION server_ifconfig creates a network interface, assigns an IP address to a
network interface, enables and disables an interface, sets the MTU
size and the VLAN ID, and displays network interface parameters for
the specified Data Mover.
server_ifconfig is used to define the network address of each
interface existing on a machine and to redefine an interface’s address
and operating parameters.
The ALL option executes the command for all of the Data Movers.
OPTIONS -all
Displays parameters for all configured interfaces.
-delete <if_name>
Deletes a network interface configuration.
-create -Device <device_name> -name <if_name> -protocol
{IP <ipaddr> <ipmask> <ipbroadcast>}
Creates a network interface configuration on the specified device,
with the specified name, and assigns a protocol to the interface.
Available protocols are:
IP <ipaddr> <ipmask> <ipbroadcast>
Assigns the IP protocol with the specified IP address, mask, and
broadcast address. The IP address is the address of a particular
machine. Multiple interfaces are allowed per device, each identified
by a different IP address. The IP mask includes the network part of
the local address and the subnet, which is taken from the host field of
the address. For example, 255.255.255.0 would be a mask for a Class
C network. The IP broadcast is a special destination address that
To Next Page
Loading...
Need help?
General
