To Next Page

To Previous Page

394

Celerra Network Server Command Reference Manual

The server Commands

1088091483: KERNEL: 4: System BIOS Rev Barracuda

1088091483: KERNEL: 4: PCI BIOS Rev 02.10

1088091483: ADMIN: 4: Command succeeded: device pci pci-0

1088091483: ADMIN: 4: Command succeeded: dskdumpconfig full slot=2

Note: This is a partial listing due to the length of the output.

EXAMPLE #2 To display the current log, type:

$ server_log server_2

NAS LOG for slot 2:

--------------------

2004-06-24 11:37:59: ADMIN: 4: Command succeeded: logsys add output

disk=root_log_2 bufsz=256

2004-06-24 11:37:59: ADMIN: 4: Command succeeded: logsys add output event

bufsz=2048

2004-06-24 11:37:59: ADMIN: 4: Command succeeded: uniqueid

validate=LKE00033201518

2004-06-24 11:37:59: ADMIN: 4: Command succeeded: param config

cs_ip=128.221.252.100:128.221.252.101:128.221.253.100:128.221.253.101

2004-06-24 11:37:59: ADMIN: 4: Command succeeded: param kernel autoreboot=600

2004-06-24 11:37:59: ADMIN: 4: Command succeeded: param NDMP md5=1

2004-06-24 11:37:59: ADMIN: 4: Command succeeded: param PAX paxWriteBuff=64

2004-06-24 11:37:59: ADMIN: 4: Command succeeded: param PAX nRestore=16

2004-06-24 11:38:03: ADMIN: 4: Command succeeded: bufcache

2004-06-24 11:38:03: ADMIN: 4: Command succeeded: device isa isa-0

2004-06-24 11:38:03: KERNEL: 4: System Version-T5.3.9.2003

2004-06-24 11:38:03: KERNEL: 4: System BIOS Rev Barracuda

2004-06-24 11:38:03: KERNEL: 4: PCI BIOS Rev 02.10

2004-06-24 11:38:03: ADMIN: 4: Command succeeded: device pci pci-0

2004-06-24 11:38:03: ADMIN: 4: Command succeeded: dskdumpconfig full

Note: This is a partial listing due to the length of the output.

EXAMPLE #3 To monitor the growth of the log file with the time stamp, type:

$ server_log server_2 -f -s